-
Anonymous users2024-01-241. The water content of the object surface is high, and the temperature of the environment is too high, so you should choose a suitable weather The object should be dry and avoid contact with water.
2. The coating is too thick, and the thin layer should be applied many times.
3. The bottom layer is not well sealed, and the gas in the wooden hole pipe expands outward to form bubbles.
4 The time between coatings is not enough, and the paint must be dried before applying the next layer.
5. The time for adding curing agent is not enough, and it should be put 1. Avoid low temperature (5) high humidity (80%) environment construction.
2. It is forbidden to construct when the substrate is too wet (moisture content 10%)
3. It is forbidden to scrape putty thick at one time, and it must be thoroughly sanded after drying.
4. Each paint room must be thoroughly dried and polished until there are no bright spots before construction.
5. It is strictly forbidden to apply thick coatings at one time, otherwise it will cause the paint film to be hazy and white.
6. It is strictly forbidden to use nitro paint as the base and polyester paint as the surface.
Safety Matters. 1.Keep out of reach of children.
2.The construction site is well ventilated.
3.Do not get close to heat.
4.Avoid sticking to the skin and eyes, if it accidentally splashes into the eyes, rinse with water, if you feel unwell, please consult a doctor. 15 minutes for the bubbles to disappear before use.
-
Anonymous users2024-01-23To use "white water". Pay attention to the ratio of lacquer and thinner, rather thin than thick.
-
Anonymous users2024-01-22In summer, especially during the rainy season, this phenomenon occurs if the air is not filtered.
-
Anonymous users2024-01-21It's the same in my house now, the workers can't sandpaper the places with bubbles now, the bubbles are still there, what to do, I'm worried about this,
1. Before painting wooden furniture, wipe it with vinegar, and the luster is very bright after painting. >>>More
Environmental performance: most of the custom wardrobes are made of medium density fiberboard, moisture-proof board and other materials, hardware also has aluminum alloy, titanium alloy, etc., when we choose a custom wardrobe, we should not only check the durability and reliability of these materials, but also start from environmental protection. >>>More
Solid wood furniture painting method steps:
The first step is to remove the handle and other decorations, in order to prevent the handle and other accessories from being stained with paint, the handle and other decorations on the furniture should be removed before painting, in addition to preventing scratching the hand, it is more conducive to the uniform painting after removal. >>>More
After the wooden door and stairs at home were installed, they were painted once, it should be tung paint, and the yellow transparent is slightly like honey! But I haven't patched up some of the seams and holes, and now I want to paint them again, what should I do? .It can be treated with putty as a primer and then painted.
1. Budget.
2. Matching with the decoration environment. >>>More