-
Anonymous users2024-01-24Batch ash, sanding, brushing primer (or brushing foam water), spraying nitro white paint,
-
Anonymous users2024-01-23Natural color painting process.
Solid color coating process:
Before the paint should be fully stirred evenly, after the paint should be allowed to stand for about 10 minutes before filtering, please seal the can mouth immediately after use, so as not to enter the air and moisture, cause adverse reactions, and should be used within the specified time.
The ratio of paint and curing agent should be strictly implemented according to the label ratio on the packaging can, and the proportion of thinner can be adjusted appropriately according to different construction requirements and environments.
Do not paint this product on nitro paint or water-based wood paint; Use paints with similar properties as much as possible to avoid bottoming caused by non-solvent-resistant paints in the lower layer.
Please keep the job site clean and tidy during construction, and pay attention to the temperature (10) and relative humidity (85%) of the job site.
Some light-colored boards that have been bleached may cause chemical reactions and yellowing when painting, so they should be confirmed by small-scale tests before large-scale construction.
Some dark-colored boards that have been dyed may have a surface color fade when painting, so they should be tested and confirmed in a small area before large-scale construction.
Recoating must wait for the bottom layer to dry thoroughly, and use the corresponding sandpaper to evenly polish and remove dust without highlight before construction. Construction tools must be cleaned after use.
Keep the wood clean and dry (moisture content 12%), and remove oil, wax, moisture and other substances on the surface of the wood before construction; For example, pine and other grease materials should be treated accordingly before construction.
This product should be stored in a cool and dry place out of the reach of children, pay attention to air circulation during construction and drying, and do the necessary labor protection. Avoid contact with skin and eyes, rinse the relevant parts immediately once it touches the eyes, and go to a nearby hospital for timely medical treatment.
To say that spring can be, they are a group integrating design, production and sales.
2. Use putty to make up the level, after grinding, see if the furniture has uneven places, use putty to level, and polish it again to a flat state. If there are still dissatisfactions, continue to make up and polish again. >>>More
1. Before painting wooden furniture, wipe it with vinegar, and the luster is very bright after painting. >>>More
First of all, make sure that the wooden furniture is not damp. If it's wet, use a rag, hair dryer or heat gun to dry the furniture. When using a heat gun, keep it at a distance from furniture to avoid scorching marks or even fire. >>>More
Ways to remove dirt from wooden furniture:
Residual tea is an excellent detergent, after wiping, spray a small amount of corn flour to wipe, and finally wipe the corn clean, corn flour can adsorb the stolen goods on the surface of the furniture, so that the paint is smooth and bright. >>>More