-
Anonymous users2024-01-241. The cause of all water leakage should be cracks in the waterproof layer or a place with a missing brush.
According to the location of the leakage point on the roof downstairs, the location is determined, and then the floor tiles are chiseled and the leakage site is retreated.
There are two possibilities for water seepage downstairs, one is the leakage of domestic water to the downstairs, and the other is caused by the leakage of the buried water pipe on the ground. You can use the pressure test to see if the pressure is lost to determine whether it is a leakage of the buried water pipe, or you can turn off all the water outlet valves to observe whether the water meter rotates and walks. If there is no problem with the buried water pipe, it is only that the waterproof layer is cracked, and the cracked position can be plugged with leakage.
It's too general. Whether it's a leak in the pipe, or a leak in the floor, there must be a source of leakage.
Water enters from the brick joints, to the empty pavement, and then seeps from the pipe circumference and the concrete waterproofing to the ground below!
No way. Walking in the wall is usually the water pipe, the water pipe pressure is large, if the water leakage will be very large. The sewer pipe is an open pipe, and the sewer pipe on the sixth floor can be seen on the fifth floor, and the sewer pipe on the fifth floor can be seen on the fourth floor.
1. In order to pursue more profits, some manufacturers start to produce costs, and choose inferior materials to cause cracking at the outlet of the inlet valve and the inlet pipe itself during injection molding, resulting in sealing failure, and the water in the water tank flows into the toilet through the overflow pipe of the drainage valve, and it will flow for a long time. >>>More
First of all, we have to focus on the analysis of the cause of toilet leakage, and now many toilets leak because the toilet is used for too long, so that the internal original is damaged, for which we can replace the internal original of the toilet with a new one. Of course, in addition, damage to the outlet group inside the toilet bowl will also cause the bottom of the flush toilet to leak, in response to such a problem, we found that the toilet tank is already full of water, for which we should repair the outlet group, so as to essentially solve the problem. If the problem is serious, you can ask the maintenance personnel to repair, after all, the toilet leakage really causes a lot of inconvenience to people's daily life, and it is also a very headache. >>>More