-
Anonymous users2024-01-23Possible causes:
1. He used the raw material belt to wrap the screw teeth, and ran into the water inlet hole--- unscrewed the joint, re-wound the raw material belt, and screwed it up;
2. If the valve handle is not opened--- reopen the valve handle;
3. Did you forget to turn on the main switch when it was turned off? --Turn on the main switch of the water meter;
4. The main waterway is out of water--- see if the neighbor has water, if not, the water supply is stopped, and the power supply company is called;
5. You can invite the repairer back or ask the property hydropower master to take a look. Above.
-
Anonymous users2024-01-22Check first that the main valve installed outside or at home is closed? Because replacing the valve generally requires the main valve to be closed first.
-
Anonymous users2024-01-21In the case of making sure that there is no water outage, there is only one possibility for your problem, the valve plate and the screw rod that you called the master to repair are separated, the screw rod is the one you open the valve, and the valve plate is in it, you can't see it, it may be that the master repaired the valve when the valve was damaged, so you just change it, the valve has words on it, and there should be DN?Then the bottom is 10 or 16, go to a nearby place that sells valves or hardware plumbing to buy a replacement on the line.
1. First of all, close the water inlet pipe. Then check the water level in the tank. If the water level is too low, the toilet will not be flushed smoothly. >>>More
After repair, it will become bright, and the surface is generally matte, and the corresponding luminosity and clear paint should be sprayed. The paint should be good, it should be thin, and the spray should be thin.
There is a leather pad where the drift door is installed at the bottom, and this mat may be broken.
Open it yourself to repair, the common problem is that there is sand in it, and the closure is not tight.
It won't be so weird, right?,Turn on the faucet after the tap water overhaul and only heard that a small amount of yellow muddy water or rust water will be released.,I really haven't heard of releasing blood water.。。。 You're describing it like a horror movie!