-
Anonymous users2024-01-24Just look at the picture and you'll understand!
What is the quota for backfilling cement ceramsite on the bathroom squatting platform.
Apply the underlayment subheading.
Which one should be set if the bathroom squatting table quota is correct?
It should be the corresponding sub-heading of masonry works in the building.
Questions about restroom ceramsite backfilling.
Set of fixed amount of cushion laying. Transform the main material.
The elevation of the toilet squatting position is 150mm higher than the bathroom floor, and what is the quota balance imitating sporadic masonry, backfilling.
What is the quota for toilet squatting excavation set.
Manual excavation quota.
Slag backfill in the list quota which item.
Which province, is it a quota or a list?
How to set the quota of the equipotential terminal box in the bathroom?
Jiangsu quota province makes up 2-12
In the water supply and drainage installation quota, how to calculate the cost of reserved pipes through the holes in the floor slab?
The general set of wear fiber floor casing production and installation quota, there are waterproof requirements of the waterproof casing quota, a discount, it is really not possible to find a set of similar price, and finally it depends on how the local quota is compiled.
What quota should be set for the "washstand removal" in Sver??? Note that the sink is removed.
Sichuan's quota is unknown to other provinces.
-
Anonymous users2024-01-23Set furnace BAI slag cushion quota. du
Sunken sanitation.
When the main body is built, the structural layer of the toilet is partially or completely sunk away from the corresponding floor at a certain height (generally 40CM), so that the horizontal drainage pipe of the toilet is buried in it, and then backfilled with lightweight materials, and only a hole is required for the use of drainage risers in the structural structure. Drainage risers are reliably set in the corners of the walls, and can be covered with external curved partitions when the owners decorate.
-
Anonymous users2024-01-22The slag project in the decent chapter.
Sunken toilet filling common problems and solutions:
1. The waterproof layer of the coating film is hollow and has bubbles: mainly because the base layer is not clean, or because the screed layer is wet, the moisture content is higher than 90%, and the moisture content test is not carried out before painting, resulting in hollowing, and in serious cases, it causes a large area of bulging. Therefore, before applying the waterproof layer, the base layer must be cleaned and the moisture content test must be done. >>>More
Lightweight materials or overhead, lightweight materials include ceramsite, lightweight bricks, cinders.
Elder brother.. You're so imaginative, you can't fill this thing with broken foam. >>>More
The installation perimeter of the complete set of distribution boxes.
In fact, relatively speaking, the sunken bathroom is more waterproof 。Now when we design the bathroom, in fact, we will take into account its waterproof performance more fully, after all, in the bathroom area, a lot of water is often used, if the waterproof work of the bathroom is not done well, then it will make all kinds of problems in the process of subsequent check-in. >>>More