-
Anonymous users2024-01-24Is not a large wardrobe sliding door, 10 cm enough.
-
Anonymous users2024-01-23The general sliding door track is 84mm, and the general reserved position is 100mm, and now there is a track width of 70mm, but the sliding door frame corresponding to this track is also matching.
Sliding door track installation steps.
The most important thing to install the sliding door is to install the track, and the track is almost completed after the installation is completed.
1. The size of the track box on the upper part of the sliding door should be guaranteed to be 12 cm high and 9 cm wide.
Like the curtain box, the track box is installed inside the track, and the sliding door can be hung on the track.
When the height of the door is less than a meter, it feels oppressive.
Therefore, when making a sliding door, the height should be at least 195 + 12 = 207 cm or more.
2. The golden size of the normal door is about 80 cm to 200 cm, under this structure, the door is relatively stable, and at the same time it is also very beautiful.
Therefore, the ratio of width to height of the sliding door should be similar to that of the golden size.
3. Be cautious of using sliding doors from the ground to the top.
Due to the excessive swing amplitude when pushing and pulling, the sliding door is easy to deform after a long time, and the door cannot be opened after deformation, which means that it cannot be repaired and cannot be used.
4. Finally, the sliding door track is installed: the upper track is fixed, and the gravity cone (hanging wire hammer) is used to hang 3 points at both ends and the midpoint of the upper track to draw out the point fixing surface with a grease pen on the ground, install the upper track, and then put a hammer to the ground at the center point of the upper track, and put the vertical line at both ends of the track, and the lower track is fixed on these 3 points, so as to ensure that the upper and lower tracks are completely parallel, and the push and pull of the sliding door is in the best state.
Just leave a 100mm gap at the front mouth, that is to say, for cabinets with a total depth of 600, you can do 500 for partitions and drawers, and the remaining 100mm is installed with rails.
The sliding door is divided into two sets of pulleys, upper and lower, and there are three kinds of pulleys: plastic pulleys, metal pulleys and glass fiber pulleys, the plastic pulleys are hard in texture, but they are easy to break, and they will be astringent and hard after being used for a long time, and they cannot slide after being blocked; Metal pulleys are very strong, but they produce noise when in contact with the track; Glass fiber toughness, wear resistance, plasticity is good, there are not only bearings in the pulley, but also aluminum blocks to fix the two wheels, so that it slides smoothly, durable, almost no noise.
The price of the more common custom-made wardrobe sliding door on the market is generally between 600-1200 yuan. The materials currently available on the market for custom wardrobe sliding doors include: >>>More
Which is better, the wardrobe sliding door or the sliding door. >>>More
Yes, but the pulley must be used well, and the personal experience is good. However, the grooves of the upper and lower slide rails must be milled out before assembly.