What are the steps for installing the gusset ceiling?

Updated on Suspended ceilings 2024-05-10
1 answers
  1. Anonymous users2024-01-23

    Introduction to the installation method of gusset ceiling.

    1. Elastic line, according to the floor elevation level, use the ruler vertical vector to the ceiling design elevation, bounce on the keel position line on the roof, and bounce the elevation line of the roof on the wall.

    2. Install the main keel boom, after the elevation level line of the roof and the position line of the main keel are bounced, determine the elevation of the lower head of the boom, and fix one end of the boom without bolt wire under the floor slab with an expansion bolt according to the position of the main keel and the hanging spacing; 6m steel bar (8mm flat steel) for the boom.

    3. Install the main keel, assemble the boom nut, precipitously code the hanger on the main keel, put the assembled main keel of the hanger, make the hanger penetrate the corresponding boom bolt according to the position of the gear line, screw the nut, connect the main keel, install the connector, adjust the elevation and straightening of the cable, install the additional main keel at the hole, and set up and connect the clamping.

Related questions
1 answers2024-05-10

1.To install a plastic gusset ceiling, the first step is to determine the location of the ceiling installation, that is, the ceiling height. Usually the ceiling should not be too low, and the height is too low to make the space seem oppressive. After determining the installation height, use the ink line to bounce the elevation on the surrounding walls, and the baseline should be clearly marked; >>>More

1 answers2024-05-10

How to install a plastic gusset ceiling? Plastic gusset ceiling construction technology: >>>More

2 answers2024-05-10

1. The corner lines required on the four sides of the room are cut according to the actual size of the wall, which must be carried out according to the actual measurement accuracy of the size of the wall of the room. >>>More

2 answers2024-05-10

First, the elastic line.

According to the floor elevation level, use the ruler vertical vector to the ceiling design elevation, bounce on the roof on the keel position line, and bounce the elevation line of the roof on the wall. >>>More

9 answers2024-05-10

Õ¹¿

ÚÈ6mµÄ¸ >>>More