What to pay attention to in the installation of solid wood wall panels

Solid wood wall panel installation – keep the wall clean.

Before installation, the wall should be clean, dry and flat, and the height of the elastic line should be leveled, in order to adapt to the local climate conditions and achieve the moisture content of the air, the purchased wall panel should be unpacked and stored in situ for at least 48 hours before installation.

Solid wood wall panel installation – pre-sized design.

Before the panel is installed, the size of the block should be designed first, and each block should be squared and straightened and then tested once, and then formally nailed after adjustment and repair, so as to avoid the pattern of the surface layer is disordered, the color is uneven, the edges and corners are not straight, the surface is uneven, the seams are black and the seams are not strict.

Solid wood wall panel installation – pull the wire to check the roof panel.

Before operation, the wire should be pulled to check whether the top of the solid wood wall panel is straight, and if there is any problem, correct it in time. Avoid solid wood wall panels pressed top strip thickness not.

1. Unfairness, splitting, etc.

Solid wood wall panel installation - the wall needs to be treated with moisture.

Due to the high moisture content of wood, it is easy to shrink after drying, resulting in uneven joints or cracking. Therefore, if the wall is damp, it should be dried before construction, or moisture-proof treatment.

Solid wood wall panel installation - leave gaps on the surface of the panel.

The height difference of the surface of the solid wood wall panel should be less than; The width of the seam between the plate surfaces should be uniform, and the size deviation should not be greater than 2mm; The diagonal length deviation of a single panel is not more than 2mm; The verticality deviation of the panel is not more than 2mm.

Solid wood wall panel installation - the yin and yang corners should be horizontal and vertical.

The yin and yang corners of solid wood wallboard are the key and difficult points of construction, and special attention should be paid to them. The yin and yang angles must be vertical and horizontal, and the seam splicing is 45°.

Solid wood wall panel installation - the baseboard and the bead should be close to the panel.

The baseboard and bead should fit snugly against the panel without leaving too many gaps. The spacing of the nails of the fixed baseboard or pressing strip shall generally not be greater than 300mm; The nail cap should be flattened, and the depth into the slats should be, and the nail holes should be smoothed with oily putty of the same color.