-
Anonymous users2024-01-23First, install the door frame, place it into the door opening, and fix it with wooden screws, then start drilling the counterbore holes and fix them with expansion screws. Then use styrofoam or cement slurry to fill the gap between the door frame and the wall, and after it dries, the door frame line is glued, and the door stop line is nailed with a nail gun. Finally, install the door leaf according to the position of the door frame hinge.
The first step is to assemble the door cover. First, find out the door sleeve and the vertical plate, align the joint according to the back number, and the mouth should be on the same plane, and the glue should be applied at the interface.
2 6 The second step, install the door cover. Put the assembled door sleeve into the door hole as a whole, use small wooden strips to roughly fix the door sleeve around, the two sides of the door sleeve should be on the same plane with the wall, and then check whether the door sleeve is perpendicular to the ground as a whole, whether the two angles of the top plate of the door sleeve and the two vertical plates are right angles, whether the door sleeve vertical plate is bent, and twist the iron sheet at both ends to make it wrap the wall.
Baoding Holz wooden door, China's top ten brand wooden doors to join the investment.
Advertisement 3 6 The third step, install the door leaf. Open and close the slot first, and the distance between the hinge slot and the two ends of the door leaf is 1 10 of the height of the door leaf.
Wooden door installation comes to 58.com long-term warranty!
Advertisement 4 6 Step 4, install the door lock. After installation, check whether the door leaf and door lock switch are flexible, whether the seams are flexible, and whether the seams meet the specifications.
Taiming Door Industry Steel Door Office Door Manufacturer Mass Customization is trustworthy.
Advertising loves procurement.
Advertising Hotel Medium Door Closer Manufacturer Supply Automatic Door Closer Door Closer Door Closer Hydraulic Cushion Medium Door Closer Access Control System.
51 yuan. View 5 of 6
The fifth step is to install the door sleeve line. Cut the door sleeve line with right-angled edge into a 45-degree angle, trim it with woodworking, insert the right-angled edge into the door sleeve groove, and glue the door sleeve line and the door sleeve board firmly with floor glue.
Solid wood doors are very important for every family, not only for home decoration has a good decorative effect, but also plays a role in separating space. Solid wood door installation can be said to be the most important step in the decoration of wooden doors, if the installation is not in place, it is easy to cause the wooden door to fall off or deform in use. >>>More
1.Installation conditions.
1) The wooden door must be installed with a reserved opening, and it is strictly forbidden to install the masonry at the same time. >>>More
Preparation, adjustment of the frame, fixing of the door opening, installation of the sleeve. >>>More
First determine the height and width of the door, then look at the thickness of the door cover, and then drill holes in the door wall, set the point, and use the level to locate the ......
Of course, the wooden door installation method is indispensable for its wooden door installation tools: electric hammer, carpentry hammer, planer, flat file, fine-tooth saw screwdriver, angle ruler, tape measure, hanging hammer, level, electric drill, hole opener, poke, corresponding specifications of drill bits. >>>More