-
Anonymous users2024-01-23Whether it is a new house decoration or a second-hand house renovation, as long as it involves the groundbreaking of the bathroom, it is recommended to do the waterproofing again, and in principle, the original waterproof layer should not be damaged. Waterproof materials include waterproof cloth and waterproof coating, and more waterproof coatings are used at present
1. Clean the surface.
Clean the base layer of the restroom, including dust, sand, cement, etc.
2. Grassroots treatment.
The ground is leveled and sloped, and if there are cracks, hollows, and defects on the wall, use cement to smooth out the base to ensure that the base is firm and smooth.
3. Make an arc at the angle of yin and yang.
The yin and yang corners of the bathroom and the root of the water pipe should avoid dead corners, make an arc and straighten.
4. Waterproof key parts.
The parts with the greatest probability of water leakage are mainly the yin and yang corners and the root of the water pipe, and in order to reduce the risk of water leakage, these parts should be waterproofed first.
5. Waterproof for the first time.
It is recommended to use a brush, not a roller brush, the brush is more delicate and has fewer loopholes.
6. Waterproof for the second time.
The second waterproofing and the first waterproofing should have a cross way, which can reduce the possibility of missing brushes. Waterproofing is generally done two to three times, and the thickness of each pass is controlled around the right.
7. The threshold is also a key part of waterproofing.
There is a possibility of water seeping out at the threshold, so pay extra attention when brushing waterproofing. The control threshold is 2-3cm higher than the bathroom, and the threshold stone should be wet pasted, and it is best to paste the threshold stone first, and then focus on brushing the waterproof side of the threshold stone.
-
Anonymous users2024-01-22This is actually good to do a few more times.
After all, the situation is different.
You need to post it a few more times.
You need to be a little more detailed.
-
Anonymous users2024-01-21Why not find a professional waterproofing one. It is not up to the professional level to make the bathroom waterproofing yourself. No other project in the province can save waterproof.
First, pay-off, elastic line.
According to the size, wall modeling, location and other requirements on the design drawings, first draw the horizontal elevation line and the peripheral contour line on the wall, and then pop out the keel grid line. Add wooden pegs to the wall according to the grid line, or pre-bury wooden bricks or fixed iron parts when building the wall. The position of wooden bricks and iron parts should conform to the size of the keel bin, and the horizontal and vertical spacing of the wooden keel on the flat wall is generally not more than 400. >>>More
Installation steps: 1. The keel ceiling hanger is fixed with expansion bolts and reinforced concrete slabs; >>>More
The first step, before the waterproof treatment of the bathroom, the first thing is to level the floor level of the bathroom, the ground is uneven, when the waterproof paint is painted, it may be uneven, or the ground is easy to crack because of unevenness, which will crack with the ground even if the waterproof paint is applied. >>>More
Bathroom decoration is a more important part of the home decoration, and the bathroom waterproof construction is the key to the bathroom decoration, if the bathroom waterproof construction work is not dealt with, it will bring a lot of problems to our daily life, and it is difficult to construct again, so in the process of home decoration, the bathroom waterproof construction work should be paid attention to, the following Fuwo for you to share the correct bathroom waterproof construction method, I hope to help you. >>>More
To do waterproofing, you need to do it on the front of the water. >>>More