-
Anonymous users2024-01-23Can not do waterproof on the floor tiles, but also can not pave the floor tiles on the floor tiles, can only knock off the original floor tiles, do waterproofing, and then pave the floor tiles, the waterproof layer should extend from the ground to the wall, 250MM higher than the ground According to the conventional waterproof layer height of the shower head wall shall not be less than 1800MM, the general thickness shall not be less than 1 5MM, and the waterproof project must be completed 24 hours of water storage experiment. If you don't want to be troublesome, the best thing is to buy a full bath.
Or partitions are more practical. The partition can completely solve the problem of waterproofing. >>>More
Just find a property, just urge the other party to do a good job of waterproofing!
If you are planning to have children, then don't dismantle it, it is still convenient to bathe small children in the bathtub. Otherwise it's too much trouble.
This depends on whether your ground is flat, if it is flat, it should not be a big problem to put a layer of glass glue on the shower room, but it is best to check his closure when playing glass glue, and there must be no leakage. The best way is to install a water retaining strip, which doesn't cost much and is not that troublesome.
The walls should be waterproof, the shower walls should be meters, and the other walls should be meters. If you don't, you won't see that the wall tiles can't penetrate, the wall tiles can't accumulate water, and drain quickly. It is recommended to do this meter. >>>More