How to change the kitchen drain is high

Updated on Kitchen 2024-04-27
3 answers
  1. Anonymous users2024-01-23

    Practical workaround:

    Pump dredging method: When the kitchen drain is blocked, you can plug the hose of the pump into the drain, and then put in a small amount of water, and constantly pump air into it, and the pipe can be dredged.

    Use the water pressure dredging method: take a plastic pipe (or rubber tube) with a diameter of 10 mm and a length of about 1 meter, put one end tightly on the faucet, and insert the other end into the blockage of the pool, wrap it around the rubber pipe with a cloth, plug the drain of the pool tightly, open the faucet and screw it to the maximum, the pressure of the water is enough to wash away the blockage.

    Soda and vinegar dredging method: first pour half a cup of cooked baking soda into the drain, then pour half a cup of vinegar, and the soda reacts with the acid in the vinegar to remove the sticky things in the pipe.

    Log dredging method: first insert a log with a diameter close to the drainage outlet into the water pipe, and put a certain amount of water in the pool, and quickly pump the log up and down without interruption, and the dirt in the pipe will be washed away under the action of suction and pressure.

  2. Anonymous users2024-01-22

    The water can be treated, but the floor tiles must be planed to deal with it, and the construction is relatively simple, and the general construction team can do it.

  3. Anonymous users2024-01-21

    If the original place and the current place of the vegetable pot are in one cabinet, you don't even need to plane the wall, you can just add elbows and pipes. If the two places are too far apart, it will be difficult to get them, and even if you do it, remember that it is best not to go flat when the kitchen is drained. It's easy to block.

    Otherwise, just use a soft sewer pipe, it's easy to get it blocked, and it's a big deal to change it.

Related questions
1 answers2024-04-27

The water pipes go to the ground, regardless of the upper and lower water pipes, they all go to the ground. Regardless of whether the floor is tiled or floored, or something else, it is necessary to have a certain height of auxiliary materials on top of the floor heating, and the sewer pipe is attached to the floor heating. >>>More

1 answers2024-04-27

Two scenarios:1The ground is raised, and the pipe walks on the rough ground. 2.Blank ground groove, put a 90PPR pipe and the original 110 drainage pipe to connect. The bottom of the tank is waterproof and blocked.

1 answers2024-04-27

Bathroom switch socket should not be too low, to the meter is good, too low is easy to splash water leakage accident, if more than the meter you can slot on the tile to install another switch or socket, but so after the wall is ugly.

1 answers2024-04-27

It is convenient to have a separate sewer on the first floor. Good dredging. Not easy to block. >>>More

8 answers2024-04-27

Xiangyan kitchen, I think you can change Chinese in the settings.