-
Anonymous users2024-01-23It depends on what kind of ceiling you are? If it is an integrated ceiling, it can be removed piece by piece, and then installed after the maintenance is completed.
If it is still in the decoration stage, then leave a movable ceiling that is easy to disassemble at the maintenance end of the side cover of the electric water heater.
-
Anonymous users2024-01-22Not necessarily, depending on the maintenance content that needs to be made, whether the water heater needs to be removed.
There are clear requirements for the installation of water heaters, the right side of the water heater should be more than 30cm away from the wall, and the water heater should not be installed in the ceiling or wall, etc., these requirements are for the convenience of future maintenance. If the water heater does not need to be removed, only to repair the pressure relief valve, sewage outlet, water pipe and other parts, there is no need to remove the water heater, if it is a large maintenance, most of the water heater needs to be removed for maintenance.
When you want to remove the water heater for maintenance, you need to properly remove a part of the ceiling, if the ceiling is a type that is easy to disassemble, it will not cause damage to the ceiling, if it is a permanent ceiling, you need to destroy a part.
It is recommended to install the water heater below the ceiling when repairing or replacing the water heater, do not embed it in the ceiling, and reserve a certain amount of maintenance space between the left and right sides of the water heater and the wall.
If you want to control each other, just connect the hot water pipes. But I advise you not to connect, two water heaters gas water heaters for the vegetable basin hot water, electric water heater bath, so that you can save water and electricity, do not pre-drain a lot of cold water,.
The heat dissipation of the 10-meter pipe is still quite serious, in addition to waiting for time, the water temperature will also be affected, and the pipe should be covered with insulation material. >>>More
The hot water in the bathroom is connected to the basin, which should have been piped when it was renovated, and the walls were slotted. If it was not designed at the beginning, it could only be surface-mounted. Connect a tee in front of the hot water pipe switch in the bathroom, fix it along the wall, and then punch a hole through the wall to the top of the washbasin. >>>More
The inlet and outlet are 75-80 cm down and 10 cm in the middle of the electric top down to about 65 on the right side of the water heater and the bottom edge of the water heater is the best.
There is no problem with wrapping things outside the electric water heater, is it afraid of greasy in the kitchen? >>>More