-
Anonymous users2024-01-23The toilet flush is not enough, and the toilet is not flushed clean, which may be a problem with the toilet shifter, that is, the water outlet of the toilet is not directly facing the sewer pipe, and there is a curve in the middle, which is connected when the toilet is installed. It is also possible that the toilet is blocked, after the toilet is blocked, when flushing, the water level will slowly rise, and the toilet will not be flushed. It is also possible that when you use it, you don't have a good reason to do it, and you don't let go when you press the flush button, which will also cause the impulse to be insufficient, and you must press it for 2-3 seconds, so that you can completely open the flush valve, and the flushing effect can be the best.
-
Anonymous users2024-01-22The solution to the squatting toilet flush tank flushing force is too small.
1. The water outlet of the water tank is blocked by other parts or the opening is not complete, check it;
2. There is something blocked or blocked in the sewer pipe, or there is a bend that causes the water flow to be poor;
3. The water valve switch is not suitable, the opening is not complete or the opening is too slow, if it is a pull line, the line is too long;
4. Whether the water level of the water tank is set too low and the water is too small; Raise the water level;
Squatting toilet flush tank size.
For example, according to the type, it is divided into high water tank and low water tank. According to the installation method, it is divided into: wall-mounted, seated-box, and hidden.
According to the material, it can be divided into ceramic water tank and glass fiber reinforced plastic water tank. As for the size of the squatting toilet tank, we take the low water tank as an example, its water inlet hole diameter is generally 25mm or 29mm, and the drainage hole diameter is 65mm or 81mm.
The vertical distance from the effective working water level of the squatting toilet tank to the overflow port should not be greater than 38mm; The critical water level of the inlet valve should be higher than the water level of the overflow, and its vertical distance should not be less than 25mm; The lowest position of the non-sealed mouth of the gravity flushing device of the squatting toilet tank should be higher than the overflow level, and its vertical distance should not be less than 5mm.
-
Anonymous users2024-01-211.The water tank is not enough, the inlet valve stops the water in advance, or it is not adjusted properly. 2.The tank fittings are out of order. For example, the drain valve is not well adjusted, or the quality is problematic, and the water is sealed in advance. 3.Blockage in places such as flush pipes or squatting toilet interfaces.
There are several scenarios:
1. If the immersed buoy is stuck by the water tank wall or other parts, adjust its position; >>>More
The quality of the toilet bowl itself is defective. To buy toilets and other toilet hardware accessories, never choose cheap ones. Some manufacturers will cut corners or add their own design issues and then sell them to wholesalers at a low price. >>>More
1. The sewer pipe is blocked, and Oak Kainian throws paper towels, soap, hair and other items into the toilet bowl in daily use, which is easy to cause leakage and form backwater. 2. The toilet and the sink use the same drainage pipe, and there is no anti-bend, so the sewage will come out from under the sink. 3. The blockage of the downstairs water pipe is also easy to cause backwater.
This is because the plug did not reset the last time you flushed, and you only need to press it a few more times to hear the plug snap and it won't leak again.
There are three situations where there will be a small amount of water leakage, 1. The rubber ball valve is broken, the seal is not tight, and there is water leakage, as long as it is replaced. >>>More