-
Anonymous users2024-01-23It must be that the waterproof is not done well, after the waterproof layer is done, it is necessary to add water for 24 hours to test, the pressure of a person standing in the bathroom is far greater than the pressure of the water, and the height of the water will not exceed 10 cm.
Water leakage, waterproofing layer needs to be redone.
-
Anonymous users2024-01-22As long as there is no hole punched in the construction after the waterproofing, it is generally because the waterproofing is not done well, and the possibility of damage during the construction is not ruled out
After doing waterproofing, the time of the closed water test is 48-72 hours, and you can do the closed water test after the waterproof layer is completely dry, generally about 24 hours can be completely dry (2 days ago, it is recommended to do the waterproof for about two days in 48 hours (the time is not standardized, the standard is to see if the waterproof is dry), 24 hours after the closed water test, go downstairs to see if there is a water leak. >>>More
As long as the closed water test is qualified, the conventional drainage will not damage the waterproof layer, if you are not at ease, let the workers take a look at the site to help you make a judgment.
If there is a water inlet in the wet area at the door, it is likely that the water seepage is from the water outlet. Another possibility is that the tile joints are seeping water.
Before laying the bathroom floor, it needs to be waterproofed! There is a special waterproofing agent! After the treatment is dry, then release the water to test the waterproof effect, if there is immersion in the water, you need to do it again! Until you are satisfied!
Put ice cubes on the ground in the middle will. Breaking the waterproof? Putting ice on the floor of the bathroom will not break the waterproofing.