How to adjust the water level of the toilet tank

Method steps.

First of all, we lift the lid of the toilet, pay attention to be sure to hold it steady, handle it gently, and do not bump it.

We see that there are two black columns on the toilet lid, this is the toilet water connecting rod, this can be adjusted to control the strength of the toilet button, this should not be adjusted too long, so that the lid can just touch the blue and yellow blocks below. It can be adjusted to one long and one short, for example, you can press the small button on the lid when you are done urinating, and the drainage is relatively small.

If the water level is higher than the overflow pipe, then we adjust the position of the float on the left, rotate the white rod in the circle, which can be used to adjust the high and low position of the float, after rotating a few times, release part of the water, and then observe the water level after the water storage stops until it reaches the satisfactory position.

At the same time, we also see that in front of this water button, there is a yellow block that can be moved up and down, this is used to adjust the toilet drainage, if you feel that the toilet button is pressed once, the drainage is too large or too small, you can adjust the height of this small yellow block, so as to achieve a satisfactory drainage.

If you put an appropriate amount of empty water bottles, you can reduce the water level of the tank by tying them to a fixed place.

Fine-tuning of the water level of the water inlet valve tank: The adjustment lever can make the water level of the water tank rise or fall. When the adjustment lever is rotated counterclockwise, the float box descends and the tank water level decreases. On the contrary, by rotating the adjustment lever clockwise, the floating box rises, and the water level of the tank rises.

Adjustment of the drain valve (large drain adjustment) As shown in the figure, the adjustment section switch can make the drain valve drain large. When the regulator switch moves down to seal the hole, the displacement is larger. Conversely, moving upwards opens the hole and distributes less water.

Open the upper lid of the toilet, there are two buttons on the lid of the water tank, one is a small amount of water, the other is a large amount of water, the water tank of the toilet is generally a general rule is less up and down more, if you want the water output of full drainage and semi-drainage is the largest, just adjust the two buttons to the bottom, and the full drainage should be adjusted to the bottom, because the full drainage is generally used to flush the stool, and the larger the amount of water, the better. Semi-draining is used for urinating, and generally does not need to use a large amount of water, so it is appropriate to adjust it to the middle position.

It is to adjust the iron rod downward, so that the float is adjusted downward, the needle valve is closed in advance, and the water level of the toilet tank is reduced