-
Anonymous users2024-01-23Make up the waterproof layer, add a layer of waterproof membrane and roll up 200, the waterproof mortar effect is relatively poor, and paint a layer of waterproof mortar on the wall. Generally, when the mid-range or above residential area is decorated, the waterproofing will be done again.
-
Anonymous users2024-01-22Wipe it with waterproof mortar, and then pave it twice with waterproof membrane, and paste bricks on it. Pay attention to the undercut part in the process, this can be better, and it should be fine.
-
Anonymous users2024-01-21First plain cement leveling, then spraying with silicone, and then doing flexible waterproofing.
If it is not discharged to the outside of the wall alone, it is connected up and down, from the bottom to the top, so it is best to install a door that can prevent return air in the exhaust hole of your own home.
Kitchen and bathroom exhaust flue specifications of residential buildings are 370, 240, 120, 60 and other specifications;
1.It is necessary for us to find a household exhaust fan to observe whether there is a PE terminal 2It is possible to have an outlet or not, but it will definitely need to be connected to the lighting circuit and controlled by the light switch.
Among them, there are two codes that mention this problem, one is the "General Principles for the Design of Civil Buildings" GB 50352-2005 Article 6 12 3: toilets, kitchens and other floors that are often soaked with water or non-corrosive liquids should be waterproof and non-slip surface layer, and should be lower than the adjacent floor ground, and set up drainage slope slope floor drain. >>>More
The bathroom waterproof construction floor is all painted; Generally the wall is repainted and brushed 30 cm high; The walls around the shower area are repainted 180 cm high. >>>More