How to install the bathroom washbasin countertop panel to be firm

The 5*5 angle steel is made into a frame, and the iron is expanded and fixed. You can also chisel a few holes in the wall, drive the angle steel into it, and enter it at least 10cm, so that its surface will not turn over, it must be horizontal, and then support a template below, and then pour cement, and put a few steel bars horizontally, remember to leave the sewer hole. After a few days, you can put tiles, this method is a bit cumbersome, but it is stronger than the frame, and the height of the water is calculated, and the sewer pipe is buried in the wall.

The inside of this kind of countertop must be framed with 40 angle steel and fixed in the wall, and then the base layer + exterior decoration tiles must be made.

First of all, the wall that needs to install the countertop can not be a hollow wall or filled with environmentally friendly black bricks, preferably a red brick wall or a concrete wall, you can use 40 angle steel to make a square iron shelf, and use iron expansion bolts to hit the two walls behind the faucet and on the left side of the countertop picture, and customize the countertop in measuring the specific size.

As for the concealment of the sewer and upper pipes, it is necessary to set the height of the countertop before changing it into the wall.

1. Leave enough distance between the two basins, otherwise they will affect each other when they are used.

2. Due to the staggered under-counter bracket of the undercounter basin and the complexity of disassembly and assembly, it is difficult to ensure the installation quality during installation if the length of the countertop is small.

3. After the installation of the undercounter basin, the overall appearance is relatively neat and easy to take care of, and it should be noted that the joint between the basin and the countertop is a place where it is easier to hide dirt and dirt to prevent mildew.

4. The undercounter basin has higher requirements for the installation process, first of all, the installation bracket should be customized according to the size of the undercounter basin, and then the undercounter basin should be installed in the predetermined position, and after the bracket is fixed, the countertop that has been opened will be covered on the undercounter basin and fixed on the wall (generally the angle iron is used to support the countertop and then fix it with the wall).