How to install the bathroom wash basin

There are different installation methods for various types, taking the more common wall-mounted and floor-mounted types as examples

1.General similarities: the design and installation location as far as possible near the door for ease of use, reserve the water outlet in the center of the wall at about 50, the mirror lamp reserved line m center on the wall, first install the lens and sideboard, and then install the main cabinet or bracket, and then put on the countertop that has installed the faucet drainage, test the water after connecting the pipe, and play anti-mildew glue in the gap between the wall after the basin, and the height of the washbasin mouth is about 80, and pay attention not to hurt the hidden pipeline during installation.

2.Differences: The wall-mounted type requires the wall to be a solid (clay brick is preferred) wall, the floor cabinet does not need to have waterproof isolation adjustment feet, if there is a special-shaped size, it is recommended to use a stone countertop that can be cut, and the conventional ceramic basin is more durable and cost-effective.

One. Basic concepts.

1.The washbasin is also called washbasin, basin, and its function is a container for washing hands and face2In the early days, it was made of wood, and later improved into a porcelain iron basin.

3.That is, the inside is iron, and the exterior is covered with a layer of porcelain.

4.After a bump, you can see the iron inside.

Two. Bathroom sink size.

Generally speaking, the area occupied by the toilet is 37 60 (cm);

The area occupied by the hanging washbasin is 50 70 (cm), the area occupied by the cylindrical washbasin is 40 60 (cm);

The square shower has an area of 80 80 (cm);

The standard area of the bathtub is 160 70 (cm).

You have to see whether your wash basin is a countertop basin or a column basin, 1. The countertop basin will first install the hot and cold water inlet pipe and drainage pipe on the basin, and put it directly on the countertop, and then connect the water inlet pipe to the wall triangle valve, and the drainage pipe is connected to the sewer pipe, open the valve to release water to see where there is no water leakage, and fasten it, and if there is no water leakage, the glass glue is put on the countertop last week, and it can be so after drying.

2. The column basin should first put the supporting column in the reserved sewer pipe position, the sewer pipe is in the middle of the column, put the basin on the column, close to the wall, and place it horizontally. Mark the position of the screw hole on the wall, move the basin and column, drill the hole in the wall, expand the steel and install it, and then move the column back to the position of the comparison, and the basin water inlet pipe. After the drain pipe is installed, it can be installed, if you fix the basin directly with expansion, the screws should be tightened, not too hard, otherwise the basin will be broken.

After testing the water, the perimeter of the post in contact with the ground and the place where the basin is in contact with the pillar are marked with glass glue.

Note that it is best to bend the drain pipe into a U or S shape to avoid odors.

The installation of the wash basin is explained in such detail that there is no professional tutorial!

There is a matching mounting bracket that is fixed with expansion screws.