What should I do if the toilet button doesn t pop up

First of all, it is necessary to determine the cause of the damage of the button, which is that there is a foreign object between the circlip sleeve and the button, which causes the main version of the button card to be damaged. Remove the lid of the water tank, check whether there is any foreign object in the gap between the circlip sleeve and the button, if there is no foreign object found in the gap on the surface, press the button with your fingers to feel whether there is a slight rebound force, if there is, then use a slender wire inserted into the gap between the four sides to stir up, so that the foreign object trapped in the middle can be stirred off. If there is no slight rebound, then the circlip is broken, in this case, you can only replace the circlip, look at the brand and model of the toilet, and go to the mall to buy the corresponding circlip replacement.

After convenience, press the button of flushing, at this time, the water release knob will be triggered, and the water will be released, and after a certain degree of release, the water plug will fall down to block the water outlet, stop the water outlet, and the float will also fall with the drop of the water level. When the water filling is completed, the float of the tank will also be raised, and the drainage step can be carried out again.

There will be two buttons on the toilet, these two buttons are the buttons for half water and full water drainage, the small button means that it is half water, and pressing it will not completely drain the water in the tank at one time, but only put half or one-third. The big button is the full water button, and when you press it, the water in the tank is usually drained at once. The main purpose of this design is to save water, if you don't feel that you need so much water, pressing a small button is enough.

Turn it counterclockwise. And it came down. Take a shot first.

And it came up. I flush the drainage with a sprinkler well. It's all water.

Don't take it apart. You won't tear it down either. Rinse clean.

By the way, wash the water tank. I'm a professional.

There are talents! Say ZS0708 professionals.

1. The easiest way to do a copy

The method is to take the lid.

Down, just press the inside to solve the problem.

2. Take off the cover by yourself, push it out from the two push rods on the hidden surface, remove the top press, and then install it back.

3. Find a property in the community or call the phone number of the toilet seller and ask them to repair it.

The screws under the toilet seat are broken.