The kitchen faucet bolts are loosened and still can t be removed

Updated on Kitchen 2024-10-06
1 answers
  1. Anonymous users2024-01-24

    The screws of the old-fashioned faucet and water pipe interface are too tight to be unscrewed, as long as you use a pipe wrench or a movable wrench to jam the faucet with one hand, hold the inner thread with the other hand, and use fine force. It really doesn't work, only to reinstall it under the saw.

    If the screw is difficult to screw, you can spray it with rust loosening agent, and after a while, tap it with a hammer, and then twist it again.

Related questions
What to do if the kitchen faucet is loose
9 answers2024-10-06

Use a plier to remove the faucet and re-roll the water-stop tape where the screw is fixed. >>>More

How to tighten the loose pipe of the kitchen faucet at home?
3 answers2024-10-06

What to do if it's not good to screw.

The handle of the faucet in my kitchen is loose, and the water cannot be turned on, so I have to pre
1 answers2024-10-06

There is a label above the faucet, you pick it open with a pin, you can see the screw, and you can tighten it with a Phillips knife.

My kitchen faucet was loose and the water kept flowing, so I wanted to turn off the main valve, but
4 answers2024-10-06

What valve? It needs to be replaced, it is in disrepair, there is no maintenance, and no one should care about the replaced parts.

Where the kitchen faucet rotates leaks, how to remove it
1 answers2024-10-06

Just pull it up.

It is just a seal to prevent water leakage. >>>More