-
Anonymous users2024-01-24If you want to fix it yourself, first use a knife to cut the glass glue at the joint between the toilet bowl and the floor tiles, and then unscrew the bolts that hold the toilet bowl in place.
Lift the toilet a little, don't pull or push the toilet in place, it will be more troublesome if the sewer pipe is broken.
Then check whether the sewer pipe is cracked, and then connect a section of PVC pipe of the same thickness, glue it to death, put the toilet bowl on it and try it, the length may not be suitable, and then use the saw blade to see until the toilet can be placed stably, and the floor tile is close to the principle. Then test the water, no leakage, glue the base to the floor tile with glass glue, and tighten the screws to fix the toilet. Take over the toilet bowl within three days, don't shake it back and forth, and wait for the glass glue to dry and you'll be fine.
It is recommended that you don't get it, you are not a professional plumber who has never been exposed to these things, even if you repair the toilet, you may leak from the pipe if you don't connect the flange of the water pipe and the water tank.
The water inlet hose is leaking because it has been used for a long time, and it is enough to tighten it with a wrench.
Find a professional maintenance personnel to repair it, or you can disassemble it yourself to see if the pipe is not clamped or damaged, depending on the specific situation.
Break the edge of the toilet bowl with glue and you'll be fine. >>>More
How to deal with leakage of toilet inlet valve.
1. Check whether the flush switch is reset. The plastic flush switch of some flush toilets has been worn for a long time, and occasionally there will be a phenomenon that it cannot be reset, if it cannot be reset, then it can be switched on and off several times, so that it can be reset. There is also to check whether the rubber gasket of the drain port under the ball valve is aging, the sealing is not tight, etc., and if the problem is found, it should be replaced, so as not to affect the use. >>>More
I used to sell sanitary ware.
If the water is still in the water when it is full, the float in the inlet valve is broken or stuck after the float rises to a suitable height, and the water inlet cannot be sealed by buoyancy, so the water will not stop! >>>More