What is the reason why the bathroom is covered with tiles and hollow drums, and even waterproofing i

Updated on Bathroom 2024-10-02
1 answers
  1. Anonymous users2024-01-24

    The reason for the adhesion of tiles and waterproof layers is also related to the fact that the waterproof layer is not strong.

Related questions
There are many hollow drums in the bathroom, and after removing it, it is found that the bricks do n
2 answers2024-10-02

After the wall is built, there is no batch of a layer of interface agent and a layer of interface agent for mesh cloth, and then there will be no empty valley if you use tile adhesive to paste tiles.

How to remove the bathroom light tube
3 answers2024-10-02

Turn it at a 90° angle to take it down.

How to remove the bathroom ceiling
1 answers2024-10-02

Depending on what the top is, some of them seem to be able to go straight up, and some of them need to be taken off first.

How to remove the waterproof adhesive strip in the bathroom and reinstall it with a good effect?
1 answers2024-10-02

The bathroom is waterproof, remove the adhesive strip and install it back as it is.

How to remove the bathroom ceiling light if it is broken
3 answers2024-10-02

The bathroom has integrated lights, barrel lights, warm lights, generally mostly integrated lights, there are heating exhausts, if this is the case, the light panel is stuck on, you take a closer look, only take the light panel and change the lamp tube after the card on the line, the barrel light is much simpler, remember that you must first pull down the total tie.