-
Anonymous users2024-01-24Due to the large water consumption of the shower room, it is necessary to install a water retaining strip. How to install the shower room water retaining strip? PChouse will take you to find out.
There are several ways to construct the shower room water retaining strip:
1. When laying floor tiles, leave a groove, and after the cement mortar has been paved, put in the marble water retaining strip.
2. Use bricks to build the shape of the water retaining strip, and then pave the floor tiles or marble pieces.
Installation steps: Embed the water retaining strip in the floor tiles when laying the floor tiles. Some sellers boast about how good the skirted water retaining strip is, but in fact misleading consumers.
The skirt is only a few millimeters higher on the outer edge of the retaining strip, which is actually used to make a stone foundation under the shower room with glass, the glass is placed in the middle of the retaining strip, and the skirt is to prevent water from seeping into the retaining strip from under the glass. Supporting the shower curtain with a water retaining strip, measure the installation height during installation, so that the shower curtain naturally sags, hanging into the water retaining strip about three centimeters, this is the best installation effect, and after installation, the water will not splash at all. The biggest disadvantage of the skirt is that if there is no glass pressed on the water retaining strip, due to the uneven high stress on the inside and outside of the water retaining strip, the glass glue below will be loose after a long time.
When installing, determine the location first. The hollow stone foundation is first filled with mortar. Then it's good to lay horizontally, remember to find horizontal laying.
Natural marble is the best, generally do a good job of waterproofing, prevention, drainage can flow smoothly away.
According to the width of your water retaining strip, first squeeze the glass glue (waterproof type) on a clean ground or wall, press the waterproof strip on it, and wipe the glass glue extruded by the water retaining strip with your fingers after dipping it in some water, form a sealed state, and dry it, so that according to the frequency of your home bathroom, you have to re-glue it every two years or so.
The installation of the water retaining line of the shower room, after adjusting the size, can be glued with glass glue, but both sides of the water retaining line are all the places that are in contact with the wall or the ground must be beaten with glass glue, and there can be no gaps, and after the glass glue is laid, it can not be moved, it must be protected, and it can be used after 24 hours.
The purpose of the automatic water storage shower room is to store the water after the shower for use in the toilet. The utility model adds a water tank below the shower room, the water tank is provided with a water inlet and a drainage outlet, and a water storage switch is arranged on the water inlet and the drainage outlet; A water tank is installed on the shower room, and the water tank is provided with a water inlet and a water outlet, and the water outlet is connected with the toilet water inlet; A water pump is installed on the upper water tank, and the water pump pumping pipe and the water outlet pipe are connected to the lower water tank and the upper water tank respectively; In the upper and lower tanks, floats that can sense the water level of the water tank are installed respectively, and are connected with the contact switch through the float connecting rod; The contact switch is connected in series with the water pump on the circuit. The utility model can automatically turn on or disconnect the water pump power supply according to the change of water tank water level, complete the water tank automatic water storage, and then utilize the height drop, automatically provide water source for the toilet. >>>More