Due to the shyness of the pocket, it is planned to use ordinary paper gypsum board to make the ceili

Nowadays, most ceilings are made of this, as long as the shelves above you are strong, the board is fixed with screws, and the joints of the board are bandaged, and after a few years, there will be a little expansion joint at most. Definitely won't fall off. Of course, if the roof leaks and blisters the board, then there is no way.

Yes, my specialty is decoration design, and I'm working on a five-star hotel, and you need to put bars on the ceiling, and then seal the board with gypsum board, as long as the drywall doesn't see water.

Many decorations are being used, worrying about the sky!

The most economical ceiling renovation process:

1.First buy fine lead wire, inch steel nails, iron nails, T-shaped aluminum (keel), gypsum board.

2.The tools used are scissors (to control the length of the T-shaped aluminum and to punch holes in it), a hammer (to nail it), a wallpaper knife (to control the size of the ceiling), and a meter ruler.

3.Use a meter ruler to measure the height from the ground to your need, marking the four corners.

4.Fix the T-shaped aluminum horizontally with steel nails at the mark (cross support) that has just been made, and pay attention to the same height.

5.Depending on the size of the ceiling you purchased, make a "length standard stick" with a stick or a wooden board

6.On the purlin, use the "length standard stick" to do the standard nailing to fix the lead wire, each fixed point forks two lead wires down, the length of the lead wire sags more than 50 cm of T-shaped aluminum (horizontal support), and the fixed lead wire on the purlin is every other purlin to play a trip.

7.Fixing the long T-shaped aluminum - first make small holes in the T-aluminum every 80 cm, pass the drooping lead wire through and fix it temporarily.

8.Put the ceiling on the T-shaped aluminum bracket, use the small horizontal pallet made of T-shaped aluminum to get stuck, and use the small horizontal pallet made of T-shaped aluminum every time you put it.

9.After completion, see if the ceiling is flat, where it is uneven, where the ceiling is raised, by adjusting the lead wire to achieve the purpose, after completely leveling to fix all the lead wire.

10.The new drywall is a bit damp, so it's best to put two pieces of ventilation on top of the ceiling at both ends and put it back in after a week of complete drying.

Such a gypsum board ceiling is generally used for 10 years and 8 years will not have any problems, unless you have a leaky roof.

If your roof is not a wood purlin, can not take the above method, you can use the "plastic board" to make the ceiling, which is economical (the cost is half more expensive than gypsum board) and simple construction: first use the wooden strip to make a square bracket is convenient for you to install lighting appliances), after fixing the upper horizontal support, directly to the groove of the card board, "over the plastic board" also has a card slot, after doing it is very tight.