-
Anonymous users2024-01-24Lowering the float to increase the volume of the float immersed in the liquid can increase the buoyancy of the float, of course, water leakage may also be the result of poor sealing due to seal damage or deformation.
-
Anonymous users2024-01-23If it is determined that the water leakage is caused by the float, it is generally because the float does not float high enough, causing the water tank to continue to enter the water, and the excess water flows into the toilet from the overflow hole of the water piece. The test method is very simple, lift the float with your hands, and when the float is high enough, it will no longer enter the water.
The solution is to adjust the position of the float downward, pay attention to the float and its connecting rod to lower together, that is, to reduce the water level height of the entire linkage. Adjusting the float only downward will keep the water coming in, which will have the opposite effect.
There is a premise that the water inlet stops, no longer leaks, and it is necessary to ensure that the water in the tank can be flushed at one time, otherwise it is better to ask a professional to repair it.
One end of the crossbar of the float is fixed on the column of the water tank, it may be that the fixed screw is too tight, which affects the activity of the crossbar, so that the float can not float when the water level is full, you only need to loosen the screw a little, and the crossbar can move up and down freely.
You don't need to change it, just stick it up.
It must be in the upper middle position, huh? The float is mainly used to control the height of the water consumption of the water tank.
Check the following reels for rust or something tangled.
Tie it up with a rope and you can continue to use it. Otherwise, go outside and buy a water piece and put it on.