-
1: If it is a large area of protective film, in order to avoid the protective film tearing unsightly, it is recommended to use an angle grinder to install a wire brush head to thoroughly polish the door and then re-paint, because simple removal will make the door ugly and will also destroy the paint layer and make the door rusty. The stainless steel door is also scalded with a towel and boiling water for a while, and then torn by hand.
-
Rub vigorously with a slightly damp towel, don't use a steel wire ball brush, the paint will fall off, and the paint will smell bad if you touch up the paint later.
Splash some water on it.
Hot water is best. >>>More
Bilizo can easily mask or even remove offset printing, but it is not recommended to use it frequently to avoid fading.
You can get it down with alcohol.
Use a hair dryer on high heat for a minute or two, and it's easy to remove.
Apply some wind oil essence first, and it will be easily wiped off (suitable for small areas).