-
Anonymous users2024-01-24Just add a tee, if you want more outlets, you can add a tee, one more tee will be one more, and you need to connect with a pair of wires and seal it with a raw meal belt. Generally, hardware stores have it, just buy it with the corresponding specifications, and you should not exceed ten yuan for this little thing. It's simple, get it yourself, it's enough to have a big live wrench.
-
Anonymous users2024-01-23Buy a PR three-purpose interface, according to the diameter of your water pipe, go to the plumbing equipment store to buy one, and of course, buy water pipes and elbow joints according to the location you want to install.
-
Anonymous users2024-01-22You can install it yourself by purchasing tee joints and connectors, faucets, and sealing tape as needed.
-
Anonymous users2024-01-21This part is very common, and the interface for home use is generally 4 points. Before you buy it, you should look at whether your interface is an inner or outer wire. You can negotiate with the seller, and if it doesn't work, you can change it.
-
Anonymous users2024-01-20Yes, there is, but this thing is not easy to install, and it leaks after installation, so it's better to call a professional plumber.
-
Anonymous users2024-01-19Or do you have to find a plumber who thinks that you don't have the tools and experience, you can't install it yourself, and it's easy to leak;
-
Anonymous users2024-01-18Buy an inner wire three universal pair wire one connection.
This is due to a lack of knowledge about the filtration function of showers and faucets. >>>More
The gas water heater is only 3 cm away from the ceiling, if the ceiling material is an aluminum shell, it is not a big problem, if it is a plastic material that is easy to melt, you need to be careful. >>>More
The water heater is installed under normal conditions, and the water can be connected to the water heater with a hose. Generally, it does not affect the size of the effluent.
Yes, stock an inner connection, a tee, and a faucet. Remove the original faucet, install the inner connection and then install the tee, and then install two faucets on the remaining two mouths of the tee, pay attention to prepare a little raw material belt and wrap it around the thread of the inner connection and the faucet, otherwise it will leak.
You can install a pipeline circulation, parallel to the hot water pipe, one end is connected with the water tank, the other end is connected with the outlet end of the hot water pipe, install a circulating pump, start the circulation pump first to make the water temperature of the outlet equal to the water tank and then use the water OK, but this will lose some heat. Another method is to use the cold water released in a container and then dry it for other purposes, so that there is no waste of waste water and no heat, which is the trouble point.