-
Anonymous users2024-01-24The top gusset of the ceiling can be installed last, because when the gypsum board ceiling is done in the early stage, the gap for the installation of the gusset has been reserved, and the main body of the paint can be installed, so as not to make the paint to the top of the difficult treatment. You can install the top lamps when you install them, generally there will be a layer of protective film on the top of the new buckle, if there is a gap on the edge in the later stage, you can make up the paint a little, and tear off the effect after installation.
Gypsum board ceilings need to be painted with latex paint. The gypsum board ceiling is the same as the blank ceiling. Gypsum board can not be directly brushed on the gypsum board, gypsum board is made of two layers of paper sandwiched with gypsum powder, direct brushing will absorb all the moisture of the latex paint into the interior of the gypsum board. >>>More
Shovel it out and start over.
The yellowing and discoloration should be the putty before it dries and the latex paint is on. >>>More
It's not finished! It should be white latex paint made latex paint and then it should be sprayed with paint, right? If it is yellowed by paint, I have encountered such a problem, and the gypsum board is not good, the primer used by the decoration staff is also crooked, it is easy to see through, and the good latex paint primer is not easy to dry after brushing the top paint, if the topcoat is sprayed or the roller rolls up to a minute to dry, then it must be crooked latex paint, I hope to adopt it.
The gypsum board ceiling is brushed with putty and latex paint, and the color will also turn yellow. This situation is likely to be related to the quality of latex paint, or related to the environment, such as frequent oil smoke or exposure to the sun.
The bulge may be due to the fact that the screws are not tightened, try to drill in it again with a hand drill. Be careful not to drill too hard to prevent the drywall from breaking.