-
Suck in with a suction cup and pull down.
-
Pick it off and open it.
-
Buckle off the edges.
-
Open the panel of lights.
Check if the lamp is not broken before cutting off the power supply to prevent electric shock, and then remove the lampshade, check whether the lamp joint is loose, turn on the lamp after tightening, if it is on, it means that it is caused by poor contact, if it is still not lit, you can check whether the lamp joint is black and dark, if there is, you can basically determine that it is a problem with the lamp, just remove the old lamp and replace it with a new lamp. >>>More
Grab the plastic in the middle of the middle tube and pull it down. Install the groove and push it up to install it.
Cut off the power first. If it is an integral cassette lamp, you can directly remove the lamp by holding the lamp tray with both hands. If the inner fruit is a lamp plate buckle type ceiling lamp, first use a flathead screwdriver or blade, insert it in the middle of the transparent cover and the white edge to force outward, there will be a big crack, you can see that there are three clips on the cover, put the screwdriver in the position with the card, and then force outward, see that the card is not stuck in the inside, in the upward force, get out of a card, the remaining two cards can be easily opened, and the lampshade can be pulled out by hand.
I'm doing the decoration piece, what you said is very simple, I'll give you a brief introduction here. Method 1: Push the partition of the kitchen lamp upward, if it can't be pushed, find a blade around the partition of the lamp, rotate it, move it left and right after touching something, and push it up again. >>>More
Re: - Cut off the power supply first, remove the cover, unscrew the screws, cut off the wire, and close the ......... of the wire