-
Anonymous users2024-01-24Your current situation should be that part of the water heater is buried in the ceiling, the ceiling before the installation did not move, just dug a hole, now that the installation is completed, it is found that the hole is digged large, and there is a hollow area between the edge of the ceiling plate and the water heater, right?
If you have a problem with your construction, there is no good way to solve it, depending on the content of your problem, you don't ask for a particularly good look, or you can seal the gap, don't be too ugly, right? (In fact, it's useless for you to ask for good looks, there is no way to solve it, unless you change the ceiling).
Solution Measure the length and width of the perimeter of your water heater and buy three PVC gussets (there are gaps in the three directions, right?). ), longer than the gap around your water heater (about 10 cm long each), and then put the ceiling board on the top through the gap, flat on the gap, if you want to be stronger and better, you can add some glass glue (white). PVC gusset is generally 20 cm wide, and this width is fine.
Buy a seven-character edge strip and seal it around the perimeter of the one you are now destroying the ceiling, I guess yours is a PVC ceiling.
Solution Find someone who sells suspended ceilings, let them replace the roof for you, and estimate that they will have to charge an additional manual fee of about 50 yuan to deal with the position of your water heater.
The situation you are talking about is very unclear and can only be estimated. If it's the same as I said, just do it this way, there's no better way.
-
Anonymous users2024-01-23Again. The only way. The most important way to remove part of the water heater is to remove the water heater, do not put sanitary aluminum buckle plate or plastic steel plate, just find a decoration company. There is also a heater with a variable speed, which consumes a lot of electricity.
It may be that the water pressure is small, you can adjust the water output of the water heater to increase it, if not, it may be that the hot water faucet and shower of the shower are blocked, and you need to remove it for inspection.
You can add a special return line device or prepare a large bucket in the shower room, and put cold water in the bucket before each use of water to wash clothes or flush the toilet. >>>More
If you insist on using a cool shower, you don't need a water heater.
This situation should have little to do with the water heater, when there is no running water, the solar water heating is out, and the water heater cannot be used without running water. Check the tap water switch, and the mixing valve.
The simplest is to install a coal-fired boiler, the most economical is to install a commercial air energy hot water unit, or you can use solar energy with a larger water tank.