-
Hello, the gap between the joints of the solid wood floor surface layer is too large and not strict (should :
1. Reasons (1) The gluing strength is not good, the glue is not enough, and the quality of the glue is poor; (2) It is not tightened during installation; (3) Failure to dry in time, scraping at the joints; (4) There is no mallet tightening gap during installation;
2. Treatment method Replace high-quality adhesive; After the construction is completed, use the tension belt to tighten for more than two hours; Maintenance for more than 12 hours, no movement is allowed indoors; When installing, try to tighten the gap as much as possible.
Hope it helps.
Domestic solid wood floors are sealed with putty and paint on six sides, and they will bulge after a long time, and the seams between the floors will become larger.
It's better to leave more gaps!
It is recommended to leave a gap that can be covered by the baseline, which is as thick as a little finger. >>>More
From the new tightening, it can be fixed with mosquito nails at the deformation gaps, and Hengtong Xinhong anti-static floor.
In a short period of time, the floor will adapt to the surrounding temperature and humidity, and there will be shrinkage. So keep the shrink seam.
A small amount of warped skin only needs to be glued with adhesive, and it will be no problem to pay attention to care in the future. If there is a lot of warping, you need to talk to your supplier.