There are clothes poles in every house, but how to dress up and match the balcony is beautiful

Hand lift drying rack installation method.

1. Unpack the lifting drying rack in front of the customer, check that there is no damage, and count the spare parts of the drying rack, the general spare parts are: cornerer, fixed cover, lifting ring, hand crank, expansion screw, handle, wire rope, flute plug, pulley frame.

2. First install the hand crank, install the hand crank at either end of the corridor, measure the position where the hand crank needs to be installed, generally install it at a distance of one meter and two from the ground, place the hand crank at the position that needs to be installed, and then mark the hole that needs to be punched and fixed with a marker, and then remove the hand crank, use an electric drill to punch holes, install the expansion rubber plug, and fix and tighten the hand crank; Then shake out all the wire ropes in the hand crank, and when the wire rope is shaken out, the wire rope needs to be pulled to avoid messing with the line until the handle can't be rotated.

3. Determine the installation position of the pulley frame, the pulley frame is the four support points installed in the ceiling, the double pulley frame is close to the corner device, and the end is a single pulley frame, generally taking the single pulley frame as an example, the distance between the single pulley frame and the wall on both sides should be greater than 27 cm, and the distance between the two single pulley frames should be greater than 45 cm, and the general distance between the single pulley frame and the double pulley frame is 2M, but finally the installation environment is the final condition. Mark and mark the holes after determining the installation location, and then punch holes in the mounting holes.

5. After assembly, install two double pulley frames and two single pulley frames on the hole positions respectively.

6. Assemble the corner device with the expansion screw.

7. Determine the installation position of the cornerer, and the position of the cornerer must be perpendicular to the position of the hand crank, at 90 degrees.

8. After determining the installation position, mark the punch hole and install the assembled corner device.

9. The first step of threading the wire is to unpack the wire, hold one end of the two wires inside, and thread them into the corner first.

10. Then pass the two ends of the wire rope through one of the double pulley frames, the two wire ropes are parallel and do not be entangled, pull one end of the wire rope that penetrates from under the double pulley frame to the position close to the hand crank, the other end all pull through the corner device, and the other wire rope is the same operation as the front, and then the buckle at one end of the wire rope shaken out by the hand crank is hung to the tail of the wire rope of the corner device, and the other one is also operated. I put on the cap.

11. Install the ring, cut the 4 ends of the steel wire that has just been worn flat, and then pass it through the ring and tie it tightly.

12. Install the clothes rod and fix the four rings on both sides of the two clothes rods.