-
Anonymous users2024-01-24This problem is easier to solve: when the hole is dry, use a thin wire to pull a hard plastic sheet as the inner mold, seal it with glass glue, and it can be used after 36 hours.
-
Anonymous users2024-01-23The sewer pipe of cast iron pig iron is leaking and broken, and the specific operation steps are as follows:
1. Make a hoop according to the size of the tear (hole), and the hoop can be 2 3 cm larger than the tear (hole);
2. Find a rubber plate with a thickness of more than 1 mm (bicycle inner tube), and cut a piece that is 1 cm larger than the edge of the tear (hole);
3. Put the hoop on the sewer pipe, and the rubber plate is padd at the crack (hole) in the gap between the hoop and the pipe;
4. The position of the rubber plate is correct, and it is OK to fasten the hoop with bolts. This method is used for the repair of non-confined pipes of various materials. You can also find a curved iron sheet or stainless steel (the shape is just enough to cover the water pipes), and then stain it with special glue for stone.
If it is a PVC water pipe, you can buy a PVC water pipe to connect it yourself, first cut the broken pipe, put the interface into one end of the pipe first, so that the cutting position of the other end is just flush with the other opening of the interface, so that it can just be straightened, and then send it directly to this end, so that both ends have a certain cross connection distance (length) and then remove it, and use PVC glue to apply it to the inside of the two ends and the outside of the two sewer pipes. You can also buy waterproof tape to repair the sewer pipe, just wrap it up, and then use mortar waterproofing agent and cement to wipe it on.
-
Anonymous users2024-01-22Hello, do you want to know if the leak is in the field of view?
In addition, what is the material of the tube, that is, ask if the tube is the kind of spiral tube.
-
Anonymous users2024-01-21The water pipe was accidentally drilled a hole, and there was no way to make up for it, so I had to replace it again.
This is very troublesome, first of all, you have to open the wall of the bathroom, take out the whole section with holes, replace it with a new one, connect it with hot melt, repair the wall, and remember the location of water and electricity when decorating, so as to prevent the hole from being touched.
Judging from the picture that there is leakage in the connection during installation, use sealant to block, it is best not to dismantle it, find a thin wire and bend a small hook from the top to see if you can take it out, the drainage pipe may be damaged as long as it is removed, or close the tap water angle valve below, disassemble the link pipe, take down the vegetable washing basin, and dredge the ,-- from the opposite direction
Leather can be glued to patches, and cloth can be mended.
First find the dew point, and then, use a drill to destroy this part of the wall tile, you can temporarily use an adhesive to dip it, so that the loss is smaller, you can use it for a few years without a problem, and after a few years, when there is a problem again, you can replace the wall tiles and change the pipe, so as to kill two birds with one stone. >>>More
Find a small piece of the same UPVC pipe, cut it, use UPVC special glue, connect it together, and re-pour concrete on it.