-
Anonymous users2024-01-24It is better to find a property, this property is responsible. It keeps leaking, which means that there is a problem with the leak layer. It is related to the waterproof layer that was built at that time.
-
Anonymous users2024-01-23When decorating, the waterproof is not done, it is a problem at the bottom, it is difficult to repair on the surface, and if you want to completely repair it, you must knock off the tiles of the bathroom and redo the waterproof tiles.
-
Anonymous users2024-01-22Find a master to poke the perimeter of the sewer pipe with a tool, look for the leakage point, and make it waterproof.
-
Anonymous users2024-01-21Now it is not necessary to destroy the tiles and rebuild the waterproof layer directly. National patents.
It's okay to punch a hole, but after a hole is punched, there's a leak near the hole, and that's his responsibility.
Because the location of the toilet sewer pipe is low, the trap cannot be installed, in this case, two methods can be used to dispose of the water pipe, and it can be installed. The first is to cut the water pipe interface short, so that the installation space meets the installation module. The second is to reduce the height of the parallel pipes so that the installation space can be freed up.
The wind is piped, because the sewer main is connected to a gas pipe to the roof, otherwise the sewer will not go down. If the drain you said is a floor drain, there is a water trap below to form a water seal, and there will be no wind.
You can change the floor drain and buy a floor drain with a good drainage. >>>More
It should be lower than the living room to prevent the outflow of stagnant water. The drain pipe of the toilet is 100 inner diameter and 110 outer diameter, and the sewage drainage pipe should be 50mm