-
Anonymous users2024-01-24How can you be so careless.
And how can you turn on the machine in just a few minutes in the pot! Although the outside is dry, the motherboard is still wet, and some components of the motherboard will be burned out if you power it on!
Blow with a hair dryer and dry thoroughly! Then try again!
If it doesn't work, send it to customer service to check whether the software is burned!
If you change the motherboard, don't change it, buy a new one!
-
Anonymous users2024-01-23This guy from LS is very professional.
Remove the battery first, then blow it with a hair dryer, blow it slowly, don't overheat it, or dry it naturally, dry it thoroughly and try again.
I really can't go to KF to check it out.
-
Anonymous users2024-01-22Turn off and remove the battery. Tomorrow morning, I will take it to a professional place to repair my phone.
-
Anonymous users2024-01-21There is salvation, but it's almost the same as buying a new machine.
-
Anonymous users2024-01-20Don't worry, there is still salvation. Find an after-sales service provider, but because it is artificially flooded, it only needs a few days of maintenance fees to repair! Hehe.
-
Anonymous users2024-01-19Go directly to customer service to fix it! I can't figure it out myself!
-
Anonymous users2024-01-18Scoop it up and take out the battery, and then blow it on the machine with a fan for a long time, and it should be ready to use when it is dry. Don't use a hair dryer.
-
Anonymous users2024-01-17Send customer service, it is easy to break it yourself.
Hey, my 5320 just bought one and fell off the toilet for a month, and the flushing was turned off at the time, and I was flooded for about 5 seconds, and I fished it up, and it was turned off, and the screen was full of water, and the battery was removed and dried in the sun for 30 minutes, and everything was normal.
1. Quickly remove the battery, dry it with a hair dryer, put it in a ventilated and sunny place, and dry it in the sun, mainly to prevent short circuit. >>>More
Take out the battery, take it apart, dry it with a blow dryer, and rub the board again with wine clearing! OK
If it's just the phone battery falling in, it's still usable, if the phone drops, you have to take the whole phone apart and dry it before you can use it, which is how my previous phone was.
It is estimated that the built-in antenna of the mobile phone was blistered and then you used the blow blowing to blow the bad contact, and the built-in antenna is a sticker-like. Water can soak down, and when you blow it, is it blown by hot wind? If so, it is also possible that the hot air causes the antenna adhesive to age and fall off. >>>More