How to solve the problem that the toilet can t be bounced up

Here's how to solve the BAI:

1. After opening the flush toilet.

Du cover, turn it counterclockwise, and check whether there is any foreign object in the plate gap between the circlip sleeve and the button. If there is no foreign object in the gap on the surface, press the button with your finger and feel if there is still a slight rebound force.

2. If there is, then use a slender iron wire to insert it into the gap and stir it around, so that the foreign matter trapped in the middle can be stirred up.

3. If there is no slight resilience, then the circlip is broken, in this case, you can only replace the circlip, look at the brand and model of the toilet, and go to the mall to buy the corresponding circlip replacement.

I also just dealt with it, it may be that the screws on the cover above the contact spring under the top cover are loose, and you can screw some up by hand.

The flange is underneath the tank, underneath. Remove and replace the whole thing, 10 15 yuan a set.

There may be sand inside, knock on it to see how it goes, and if it doesn't work, you can only buy new water items.

I also had a similar problem with the toilet at home, and I searched the Internet for a long time and didn't find a suitable answer, so I studied it at home for a while over the weekend.

The reasons for the problem were found as follows:

The image shows two blue and white covers, buckled out, you can see that there are springs and two thin legs below with a small amount of water, and the spring elasticity is weakened.

There are signs of wear on the thin legs.

So take the following steps:

Pull out the lid and slow down, don't break it.

Change the position of the springs on both sides, so that the elastic side is good on the side where a small amount of water comes out, use a knife to scrape the thin legs under the lid, make it thinner, reduce friction and return the lid to its original position.

After treatment, the toilet bowl is currently working well.

You can press the button several times, and the scale will fall off after rubbing, and the elasticity will be restored. The simplest solution is to remove the lid and press the button inside. Find the two hidden ejector pins, push them outward, remove the ejector press, and reinstall them.

If it still doesn't work, you can find a professional maintenance personnel to come to the door for maintenance.