-
Haha, I understand this, it's not the water heater's problem, it's very likely that they messed up your water pipes. Finally, ask a third-party pair to inspect the water pipes. I remember when a friend bought an air conditioner, he asked the master who installed the air conditioner to install it, and he actually made the pipe of the air conditioner very long and wore it at the front entrance, which not only cost too much money, but also was not beautiful, which seriously affected Feng Shui.
In the end, I had to let someone else install it, and then it was installed.
-
Is it that the distance between the kitchen and the bathroom is relatively far, the water pressure is too small, and the hot water cannot be pressed. You may want to consider installing a booster pump or something.
-
If there is cold water and there is no hot water, it is the problem of the water heater, and if there is no hot water and cold water, it is the problem of tap water.
This should be fine, you can use the hose like aluminum hose to connect together.
Gas water heaters are water-controlled and have a minimum water flow requirement, which is not met, and the water heater cannot release gas and turn on the ignition and cannot be used. >>>More
If it is a gas water heater, you need to see if the faucet in your kitchen is turned on too small, or it may be that the water flow is not very smooth and the water flow is relatively small, and there is no way to reach the water flow that starts the water heater to boil water.
Is it a gas water heater? If it is, use a separate gas cylinder for the water heater, adjust the pressure reducing valve to the minimum, and the gas output is small, the fire will be small, and the water temperature will be low. If it is an electric water heater, the mixing valve can be adjusted to the appropriate temperature.
Does the water heater turn on when the bathroom is boiling hot? If it is not started, maybe the water pressure is not enough, you turn on the basin and shower faucet to try, if the distance is very far, it will take a few minutes, if the water heater is started, there is no hot water, you put the faucet in the cold water position, see if it is reversed. It's not good, maybe it's just that the pipes aren't lined up.