-
Anonymous users2024-01-24Do a test check:
1. Lift the water drift up with your hand to see if there is still water ingress, if not, then adjust the water drift position (it is to adjust the water drift to a lower position to increase buoyancy to close the water inlet valve port);
2. If there is still water inlet, then it is necessary to repair the components of the automatic water inlet valve (this is relatively complicated, and it is necessary to disassemble and check the sealing ring, nozzle, dirt, etc. one by one).
Buy the kind of medicine powder that runs through the toilet and pour it in for two hours, and it will naturally be all clear. A kind of powder of the pixel solution was moved in. After two or three hours, he will get through on his own.
That's a pretty good block. It doesn't matter, pass a few more times. Method: First, plug the toilet mouth with a towel. >>>More
1. The inlet water level is raised, and the inlet float is not sensitive, so it is enough to lower the inlet water level. >>>More
This is the following sealing flange is broken, buy a flange to remove the toilet bowl and install it from scratch.
Water seepage on the edge of the toilet bowl can scrape off the glass sealant at the contact area between the base of the toilet bowl and the floor. >>>More