-
Anonymous users2024-01-24I know Bai Dao, it turns out that I am also the last du
A dozen are first put on the board, and the edge is then glued with fast adhesive Now it is necessary to install the dao on the special line first, but the size of the inch must be mastered left and right is in addition to the corners, that is, the inner diameter is adding a centimeter If the corners are large, you can add a little more width As long as the corners can eat and live on the line The most important point is that the penultimate piece of the mother buckle should be broken first, so that it is easy to push forward I often do it within 5 minutes Very simple.
ACCORDING TO THE WIDTH OF THE SIZE OF YOUR PLASTIC GUSSET (CAN BE 10MM-15MM SMALLER THAN THE ACTUAL WIDTH), THE CUT GUSSET GROOVE INTO THE GROOVE OF THE PREVIOUS PIECE, THE SIDE THAT IS CUT OFF CAN BE CONSIDERED TO BE FIXED WITH BUBBLE NAILS, AND FINALLY PRESSED WITH THE EDGE STRIP. >>>More
Draw a line along the perimeter of the wall, punch the wooden needle under the electric hammer (including the wooden keel and the wooden needle fixed with the yin angle line), fix the keel around it, and nail the keel in the middle according to the width of the gusset to ensure that the gusset socket is well fixed with the keel. The four corners are also fixed. The last piece is narrower and can be thrown in.
Cut a gusset that is one centimeter larger than the penultimate piece to the length and width of the negative corner line of the gusset to make the last piece, and then insert the negative angle line and shoot back into the penultimate piece of tongue and groove. Don't nail the penultimate piece first, press the last piece into the groove, the size of the last piece is important, a little larger than the required size, and then shoot the last piece back after pressing the penultimate piece into the groove.
If the clip is not good-looking, put a large half of the same width at both ends, and the symmetry will look better.
Don't nail the penultimate piece first, press the last piece into the groove, the size of the last piece is important, a little larger than the required size, and then shoot the last piece back after pressing the penultimate piece into the groove. >>>More