What should I do if the width of the last piece of the aluminum gusset ceiling is not enough?

If the clip is not good-looking, put a large half of the same width at both ends, and the symmetry will look better.

The last piece of width is not enough to add another keel, and then cut a new gusset, there is no other way to solve it, this problem should not appear, before the ceiling must be calculated size, design a good keel, and then a gusset on it, any house can not be a whole board in the end, either wide or narrow, so before making the keel must be calculated, otherwise it will be very troublesome to increase the keel in the end,

This problem is often encountered in the process of suspended ceiling, only add a keel and then cut a board according to the width and put it in, basically there are few to the end just the width of a board left, when making the keel should be calculated, so as not to get the final trouble.

It is not easy to smooth the last page of the long aluminum gusset, unless the aluminum gusset is of good quality. The gap between the aluminum gusset and the lines on the last page often needs to be covered with sealant, and the last piece of the installation should be left in the middle. After the rest is installed, the remaining piece is installed. This piece is going to be shorter.

Measure the length, from the innermost part of the corner to the outermost part of the corner of this side of the short half centimeter. When installing, first insert one end to the end. Press the keel into it, and then use paper tape to pull it on the exposed side, and it's OK.

If it's not enough, you can only add a keel, and then half or buy a large size.