-
Anonymous users2024-01-24This problem I encountered a lot in the process of repairing the water heater!
The two upstairs analyzed the right problem, which is the problem of the faucet;
You don't need to change the water heater at all, it's the same situation if you change it, it's a waste of money;
The treatment method is actually very simple, just replace the water core of the faucet, which is as easy to use as a new faucet;
This is the lowest cost and doesn't cost a few bucks;
If you can't change it, just spend more money and directly replace it with a new faucet.
I have been specializing in water heater after-sales for ten years and will not mislead your (* hee-hee......
-
Anonymous users2024-01-23Definitely the water heater was blocked when the hot water flowed to the bathroom. The reason for the blockage I have encountered before: there are filters between some faucets, but after a long time, the filter holes will be blocked by a lot of small sand and other things, and this kind of faucet can be washed down in reverse.
I suggest that the faucet be turned down and then boil the water, if the water is small is the previous problem, if the water is large, it must be the faucet problem. If the faucet is blocked before it's complicated, call a special person to check it out.
-
Anonymous users2024-01-22Personally, it may be that the water pipes of the shower and washbasin in the bathroom are blocked, because now the water pipes in many communities are seriously aging, rust and fine sand appear, and the shower in my house has a small amount of water, and I opened the sprinkler head and found that there was fine sand inside.
-
Anonymous users2024-01-21No hot water or very small electric water heater.
You can consider buying a set of gas water heater without removing the scale device online, and use it to inject descaling agent into the water heater to clean the inside of the water heater and the inside of the hot water pipeline, which is simple and convenient to operate.
Generally, it is better to stain bricks as a whole, although it is dry and wet separation, and the moisture must evaporate outward after opening the door.
This should be the shower mixing faucet inlet filter screen has impurities blocked, close the main valve to remove the mixing faucet and clean the filter screen, when disassembled, cold water pipe, hot water pipe two som to rotate the same number of turns at the same time, that is, after turning the cold water, turn the hot water, it is easy to operate, try it, you can not repair it can find the property department to repair.
The bathroom does not produce water in the rain, and there is no hot water in the washbasin, and the hot water in the kitchen is stopped by the main pipe.
Most washbasins are installed at a height of 80 cm or 85 cm from the floor. >>>More