-
Anonymous users2024-01-24The water drift in the water tank is stuck, it is estimated that it was not adjusted well during installation, and it is good to open it and readjust it.
-
Anonymous users2024-01-23It's the water drift in the water tank stuck, my home has just been renovated and your situation is the same, at first I didn't pay attention, and then asked the master of the decoration, the master said to let the open and adjust it. My lover didn't understand much, so he pressed it blindly. The result is good.
The water in my toilet doesn't stop immediately after using it, even after my lover has it done. I called again to ask, and the master told me that this phenomenon was normal, and after waiting for a few seconds, it would naturally stop flowing, and it was in the backwater. After several tests, it was only 15 seconds after use that the flow stopped.
I hope it helps.
-
Anonymous users2024-01-22In the end, there is a problem with the accessories in the tank that need to be repaired.
-
Anonymous users2024-01-21The water drift in the tank is stuck.
Ways to solve the calendar: 1. If it is a problem with the sewer pipe, the solution to nuclear dust is to carefully check the interface between the toilet and the sewer pipe, and whether the rubber mat at the bottom of the pipe is too much debris, or loose, or the pipe is rotten. 2. If the pipe is rotten, you need to replace the pipe, if it is not connected, it is most likely that the gasket is not padded well, lift the water tank and adjust and fix the gasket again. >>>More
When the water in the tank is discharged, the outlet plug will automatically fall to block the water outlet, and then the float will pull the plug up with a lever because the water level in the tank drops, so that the water can enter the tank. When the water is full, the float drives the lever to close the water inlet.
The control valve is lowered a little to see if it has an effect, if there is no control valve is damaged, try to clean it, but if it doesn't work, you can only replace it. >>>More
The Wave Whale smart toilet is very bad, I didn't use it for a few months after I bought it, I called, the dealers didn't do it, and I actually bought it at home. There is no way to recognize the dealer.
1. After the water supply, check whether the float can float smoothly, if it can't float smoothly, it means that a certain part is stuck or hanged, or the float and the connecting rod position are offset and the function fails, and the float and the floating connecting rod position can be solved by re-aligning the float and the floating ball connecting rod position. >>>More