-
Anonymous users2024-01-23When the water in the tank is discharged, the outlet plug will automatically fall to block the water outlet, and then the float will pull the plug up with a lever because the water level in the tank drops, so that the water can enter the tank. When the water is full, the float drives the lever to close the water inlet.
-
Anonymous users2024-01-22There was a buoy inside, and when the water was full, the buoy floated, and it stopped by pushing the plug under the lever down to block the water outlet.
-
Anonymous users2024-01-21Using the buoyancy of the water, the water floats the ball, and the plug connected to the ball plugs the inlet.
1. After the water supply, check whether the float can float smoothly, if it can't float smoothly, it means that a certain part is stuck or hanged, or the float and the connecting rod position are offset and the function fails, and the float and the floating connecting rod position can be solved by re-aligning the float and the floating ball connecting rod position. >>>More
Adding a check valve to the water outlet means that the water can only come out, not pour it back
x0d x0a pulls the water drift up with his hands, and looks at Jing Jing to see if there is still water ingress, if not, it means that the position of the water drift is not suitable. At this point, it is enough to lower the water drift position, which can increase the buoyancy to close the inlet valve port. If there is still water inlet after lifting the water bleaching, it is very likely that there is a problem with the components of the automatic water inlet valve, and you have to ask the water master to come to Liangnian to check and repair. >>>More
It is recommended that you open it to see, because no matter what kind of water tank, the way is basically the same, as long as it is through the descent of the water float will fill the water tank, when the water is filled with the float will increase according to the water level, until the pull rod is straightened and stop filling water, so the problem you said will appear in two aspects, the first water valve is closed, and the second is that the water float may be stuck on it and not go down. You can use a manual water float to know.
This is because the tap water pressure changes when flushing, causing the gas water heater to start automatically, and the water heater will not start if you unplug the water heater electric plug.