-
Anonymous users2024-01-24Normal solid wood products or wood-based panel products will be in the splice position of the gong process line, generally less than 2mm below, if the phenomenon you say is cracked, then it is considered a substandard product, if it is the original process gap, it is not a problem.
-
Anonymous users2024-01-23Generally, there are, machines and manual will not be so precise, normal solid wood chairs will have, but it depends on the width, if you can put your fingers it is too exaggerated, normal 2-3mm is not a problem.
Solid wood furniture should be divided into many kinds, some are made of whole wood, and some are made of spliced wood. I'm not a furniture maker, so I don't know much about it. >>>More
Solid wood will inevitably have expansion and contraction, and some mahogany expansion and contraction is particularly serious, and no shrinkage joints will inevitably damage the furniture or crack.
This is for sure, because if the solid wood furniture is used for a long time, there may be some thermal expansion and contraction, so it is necessary to leave expansion joints, which is to better protect the furniture.
Generally speaking, it is necessary to reserve gaps, and the plate will expand and shrink in heat. So pay attention when installing.
Nowadays, many people like to put solid wood furniture in their homes, which is due to the fact that the texture of this furniture is particularly good-looking, and it will look special at home, but solid wood furniture will leave a telescopic space on the top when it is installed.