My phone is a Nokia 5230, and I cleaned it after falling into the toilet half a month ago, the phone

Updated on Toilets 2024-08-28
5 answers
  1. Anonymous users2024-01-24

    Restore it, it's the soft grid of the phone. *##

  2. Anonymous users2024-01-23

    There may be a short circuit damage on the hardware of the machine that has entered the water, although the mobile phone has a protection system, but it is inevitable that this situation will occur, you can find a friend or maintenance personnel to check the hardware problems.

  3. Anonymous users2024-01-22

    The motherboard burned out, go to customer service.

  4. Anonymous users2024-01-21

    Upstairs, your soft grid is ...... personalityLZ,You hard grid,Turn off,Green plus red plus take pictures and add power,Press together,Until the screen turns white,If it's not used,Brush the machine and try,It's useless,LZ just change the love machine。

  5. Anonymous users2024-01-20

    System problem! Maybe I'm going to have to fix it! Did you take the card and test it?

Related questions
2 answers2024-08-28

Then don't, or you clean and disinfect.

5 answers2024-08-28

Steps: 1. Disassemble the whole machine, and prepare the corresponding screwdriver before using. >>>More

3 answers2024-08-28

It's a blessing that it didn't burn out just after falling into it, the machine must have entered the water, it must not be clean, and it takes time to corrode it, and it may have found a place for corrosion such as solder joints, disassemble, clean, shake, and shake first, check it, re-weld the place where the virtual welding is rusty, don't go to customer service, because even if it is in the warranty, it is still charged, and it is expensive to find a store maintenance point, and it should be 100 yuan to take it down (if there is no damage to the accessories), be careful JS will change the accessories for you, and you must keep an eye on it.

12 answers2024-08-28

After the mobile phone is flooded, if the water into the mobile phone is clean water, it is easy to do, if the water is not clean, remove the mobile phone case, and clean it with alcohol The solution is; Don't panic, don't turn it on, let's repair it first! First of all, remove the battery, card, can be dismantled, the phone case is also removed, dismantle the mobile phone with a hair dryer, and then the sun comes out to dry, it is best not to bring the shell, do not dry when the sun is strong, it is easy to expose the screen, blow the wind with resistance! Two days or a day later, start to try, if there is a white screen, a flower screen, a black screen, can not be turned on and other hardware failures, can only be sent for repair, if the keyboard is not working, and press the health disorder, but also need to blow and dry. >>>More

2 answers2024-08-28

This is a little troublesome, the full name of the resistance screen is the resistance touch screen, the resistance screen is a sensor, it converts the physical position of the touch point (X, Y) in the rectangular area into a voltage representing the X coordinates and Y coordinates, the coordinates inside the water are messy, the slight click is not accurate, and the serious direct is paralyzed, in short, this thing is not easy to repair, even if it can be repaired, it can not be restored to the original state, if you want to change it, change a screen handle, about 80 100 or so, good 120 or more, See how long your phone has been used! It's been too long and there is no repair value (mobile phone Internet access, continue to ask can not continue to reply to the question, please understand).