-
Anonymous users2024-01-24Is the original height of the ground not enough (low) or is the original ground too high?
The original ground is high, and there is nothing to do but raise some ground.
low, in addition to the normal thickness of the waterproof layer, and then backfill the ground treatment.
-
Anonymous users2024-01-23Make a partition in the bathroom or a floor in the bedpan so that there is no conflict with the outside at the door.
-
Anonymous users2024-01-22The bathroom is higher than the outside, right? The bricks on the outside are high, and if the wooden floor is leveled.
-
Anonymous users2024-01-21If there is no underfloor heating, the ground can be ploughed downward, and the amount of plowing depends on the site conditions. We did.
-
Anonymous users2024-01-20I chisel to the original waterproofing layer and redo the waterproofing
If there is no laminated tiles in the bathroom and the height of the bedroom without veneer tiles is the same, then it is best to get a doorway stone and pay attention to waterproofing.
The height difference between the bathroom floor and the living room or bedroom floor will have different effects depending on the construction practice. However, the law does not specify that the floor of a room with water must be lower than that of other rooms. In most cases, the floor of the bathroom and kitchen is slightly lower than that of the other rooms, so as to prevent water from backing up into the other rooms in the presence of water. >>>More
Do not raise the height of the floor drain, and then use permeable bricks.
It is 2cm lower than the outside, but the ground must be sloped to the floor drain when laying floor tiles.
The main thing is to treat the wall tile joints, the general grout is not waterproof, and then spray the waterproof sealing paint on the entire wall, which is to prevent moisture, and the bath water generally cannot enter it, but the moisture can enter! We've handled many of these cases in this way, and all of them have been successful!