Knowledgeable friends talk about the thickness of balcony guardrails

1. All the sanitary partitions are separated out of an area for us to use, and it is not clear whether the sanitary partition you are talking about is a public toilet or a bathroom at home. In many places, the toilet area is small, but the flow of people is large, which often leads to insufficient toilets, such as shopping malls, scenic spots, etc., so how can you come out of a few more toilets in a limited space? Of course, it is to build a few more partitions in an area where everyone can use the toilet normally, and the minimum size of the sanitary partition should generally not be less than, if it is less than this size, it is difficult for a fat friend to turn around in it, and can not use the toilet well. >>>More

The balcony waterproofing must be done well, especially the pipe root and floor drain parts must be treated with waterproofing. There is no problem with putting a laundry sink.

Hello, it is recommended to use non-slip and wear-resistant floor tiles for balcony ground battles, and the water absorption rate should be low, because if it is an open-air balcony, it may be designed to rainy days, if the tiles are not non-slip, then it is likely to fall down on the balcony due to rain, so it is better to choose non-slip and wear-resistant tiles.

The load-bearing design of the balcony is generally KN per square meter, and the load-bearing capacity of the balcony is about 200 kg per square meter. The ends of the balconies are also allowed to carry 1 kn per square meter, as the ends of the balconies can also carry 100 kg of concentrated load per linear meter. The load-bearing range of the balcony is divided into two kinds, one is the self-esteem of the balcony itself, and then the balcony increases after the change into the middle, the national implementation of the balcony load-bearing design standard is 250 kg per square meter, more than this standard will bring potential safety hazards.

The perimeter is equipped with beams, and the plates are 80-100mm thick. The height of the beam on both sides of it is not less than 1 4 of the length of the pick-out;The sealing beam on its outer side is 1 10 of the span of this beam. As for the frame beams of the external walls (i.e. the height of the beams of the balcony near the interior, the height of the beam should be determined by 1 10 of its span. ）