The bathroom is raised, and the door opening is made directly on the raised countertop, under normal

Updated on Bathroom 2024-08-20
4 answers
  1. Anonymous users2024-01-24

    The normal elevation of the bathroom does not affect the door, otherwise the upper edge of the door must be raised.

  2. Anonymous users2024-01-23

    After elevation, leave a fan-shaped area on the side of the door, so that the lower edge of the bathroom door is still flush with the floor outside, and the elevation cannot be seen from the outside, so that the door looks better, but the bathroom seems to be missing a corner when used. The door opening is made directly on the raised countertop, which looks almost bad on the outside, but it feels better to use. There are two ways to do it, and you can do it according to your own requirements, but most of them are made directly on the raised countertop.

    The door leaf is generally two meters high, and if the door opening does not meet the requirements, it is required to be high on the upper edge, and do not spend money to buy depression.

  3. Anonymous users2024-01-22

    The height of the main guard door of your house.

    It's 192 cm, so is the height of the bedroom door opening the same height as the height of the guard door opening?

    Generally, the height of the interior door is uniform, or the guard door is shorter than the bedroom door. There are very few "guards that are higher than bedroom doors"!

    My suggestion is that the bathroom is raised by 20 centimeters. The height of the door frame of the main guard door is generally about 190 cm, "leave two centimeters to add seams".

    On the other hand, if the height of the door is also the same as the height of other door frames, such as the main gate, the height of the door is less than 170 cm, so it is obviously very short.

    So there are only two options: 1, the height of the guest guard door is reduced by 10 cm, which is 202 cm. At the same time, for the sake of aesthetics, the height of the door frame on the same floor should also be flush with the height of the guest door. The door opening is also 202 cm.

    2. The door opening of the guest guard door is 212 cm, and the height of other door frames on the same floor is raised to 212 cm. In this way, the height of the door will be at the same level, which is beautiful and does not feel oppressive.

    In my area, the height of the general interior door frame is 2200mm.

  4. Anonymous users2024-01-21

    Don't think about it, you must ask for the same two, otherwise the beauty is not too bad! Of course, the decoration company should discuss with you first, or the objective conditions cannot allow this!

Related questions
1 answers2024-08-20

You can find a carpenter to cut the door down 77 centimeters.

3 answers2024-08-20

In fact, as long as you find a knowledgeable master to help you renovate the toilet, it is a very simple thing for them, but it is very difficult for laymen.

2 answers2024-08-20

The bathroom floor is raised, the best material is burned cinder, good air permeability, moisture absorption, light weight, not the kind of coal cake ash to burn coal, generally have boilers, and can pass acquaintances without costing money.

5 answers2024-08-20

If the bathroom space is small and overall elevation is feasible, use a sliding door for the bathroom door. Be careful not to rinse the bathroom with water when cleaning the bathroom. so that the water does not spill out of the door.

3 answers2024-08-20

1.The cushion on the waterproof layer of the bathroom floor is thick (greater than 60), cut the ground surface layer and cushion, but do not destroy the waterproof layer, pre-buried 50 pipes, be sure to deal with the joints, and then pave the ground (mortar plus waterproofing). >>>More