-
Anonymous users2024-01-24First, determine the cause of the leakage, whether it is a failure of the waterproofing layer or a leak in the pipe.
The decoration of new houses is generally the responsibility of the decoration company, so that they can redo the waterproof layer and then lay the bricks.
Whatever the reason, the tiles have to be smashed and the waterproofing layer has to be redone.
The colorless transparent material that does not smash the bricks is not as good as advertised, and there are many big fools.
For high waterproof requirements, urea-based materials can be selected.
It is impossible to take out the whole floor tile completely, you have to use a marble cutter to cut along the edge of the floor tile, which can be about 1 cm away from the gap between the floor tiles, and then smash the floor tile and clean up the garbage, and gently chisel the gap with a chisel (or flat-blade screwdriver). In this way, the floor tiles next to it will not be damaged, and you can dig the wall groove down after completion.
If there is floor heating in the bathroom, it may be that the floor heating pipe is damaged when laying the floor tiles, causing water leakage, or the floor heat itself is leaking and the waterproofing is not done well.
Yes, there are two holes under the toilet, which can be checked on Taobao, I have seen it.
Yes, affect waterproofing.
Before laying bricks in the bathroom, the wall and the ground will be brushed waterproof, especially the location of the sewage pipe should be treated with the connection between the ground and the sewage pipe; >>>More
You can now take the following methods: put the water retaining strip on the brick surface you want to lay, thicken the low side, or open cement to fill the gap directly, no matter what method you use, as long as the upper surface of the water retaining strip is made horizontal, you can install the shower room. >>>More